Equatech LED Strip Lights 5m

SAFETY AND CARE INSTRUCTIONS • The LED strip is suitable for indoor and outdoors use but the USB MUST be plugged in indoors in a dry environment. • WARNING! This is not a toy, keep away from children and pets during use and assembly. • Carefully remove from packaging. Do not operate in packaging. • Always remove the LED strip from the reel before use. • CAUTION: Before you use or re-use this product, check for damage. Do not use if the insulation, bulbs or cable are damaged, dispose of safely. • Ensure cable is placed such, that no trip, entanglement or strangulation hazards are likely to occur. • Do not stretch, twist or trap cable. • CAUTION: Do not secure the wiring of the product with staples or nails or place on sharp hooks. • CAUTION: The product has been designed to use the included LED Controller. • Do not plug the controller into the USB socket before all other connections are made. • Do not connect this chain electrically to another product. • Keep away from heat sources, direct sunlight and naked flames. • WARNING: To avoid the risk of fire, burns or personal injury, do not cover the product with cloth, paper, or any other material not part of product when in use. • CAUTION: Do not place or mount the product near gas or electric heaters, fireplaces, candles or other similar sources of heat. • Ensure that the bulbs are not covered by decorations and ensure adequate airflow around each bulb. • Do not submerge in water or any other liquids. • Do not expose the USB to wet, damp or humid conditions. • Do not attempt to replace the “non-replaceable” bulbs. • This product should not be dismantled, as there are no serviceable or replaceable parts. • Disconnect from the USB mains supply when not in use or unattended for long periods. • This product is for decorative purposes only, it is not suitable for household illumination. INSTALLATION Before installation, ensure the surface is clean & free of dust and any sharp objects. Place the LED strip light in position, ensuring the connector box is within 3-5m range of the remote. Installing the LED Light Strip

1. Peel off the backing strip of the 3M adhesive tape.
2. Press and hold the light strip firmly against the surface.
3. Connect LED controller to the LED Light Strip.
4. Remove the isolating sheet from the battery of the remote control.
5. Connect the USB cable to the USB port on a TV or a USB wall charger.

REMOTE CONTROL BATTERY WARNING: KEEP OUT OF REACH OF CHILDREN. If the battery compartment does not close securely, stop using the product and keep it away from children. If you think batteries might have been swallowed or placed inside any part of the body, seek immediate medical attention. This light set is for indoor and outdoor use but please ensure that the USB remains indoors in a dry environment as it is not suitable for humid environments.